The reasons and analysis of the poor quality of the products issued by the cotton opener

If the quality of the flowers produced by the flowering machine is not good and contains many impurities, you can try to solve it from the following aspects to check whether the gap between the roller of the flowering machine and the thorn silver is too large. Treatment method: Adjust the gap between the roller of the flowering machine and the thorn roller.The spring pressure at both ends of the roller of the flowering machine is too small to compress the upper roller.Treatment method: The screw on the top cover of the roller frame rotates downwards to tighten the spring pressure, but do not adjust the spring lifting amplitude too much.The import of the impurity discharge board of the flowering machine is greatly increased. Treatment method: Loosen the small screws at both ends of the impurity discharge plate and adjust the inlet appropriately.The flowers are blocked at the entrance of the inspection board of the flowering machine. Treatment method: Use an air gun to clean up the cotton. The grade of the raw material of the flowering machine is not good.